What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 21.06.2025 11:20
But it can get overloaded, and no longer works.
This is where this question deviates from being a 'generic' question, and becomes more specific.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
[old diagram got deleted by accident]
(Dc diagram shown, AC is similar).
2024–10–16 [ OO OLAOYE OYEBODE ]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
It seems Mohan does not understand the difference between a comment and an Answer.
This device then solves the entire problem.
[image of Common-mode choke]
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Why are white women so overly emotional?
There are three different concepts here that are getting confused.
What does a fuse do?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
I have the power to talk to aliens through using telepathy. Why do people think I'm crazy?
The third is lightning and “how it gets conducted into a home.”
He then asserts :
2024–10–14 [Omar Gharbi Omar Gharbi ]
Why do flat Earthers exist? Why can’t I see the Sun at night? Is it because Earth is not flat?
Barnstars:
Upvotes:
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Now when you have a certain ac resistance, then a current flows in a loop.
The other is “what does a “fuse” do?”
a photo is worth a thousand words.
What is the kinkiest thing you and your sex partner have done in bed?
So, the voltage could go up to 500 volts, and the fuse will not open up.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
but this device (an Inductor) … impedes the rapid changes in the current.
What are some tips for balancing chores, work, and family life as an adult with children?
It also is a device that limits the change in current flow.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
There are two important concepts here.
First Sentence:
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Here is a simplified AC power diagram.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
The MOV will conduct when the voltage exceeds 50% of line voltage.
But… the neutral is now “floating” because of the 1 ohm resistance.
eight
Because the load is inductive, the current lags the voltage.(by a bit).
A circuit breaker is similar, but is resettable.
Edit 2024–10.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–10[John johnson John Johnson ]
He then describes Rainy Season and Lightning.
the problem then depends on "how fast does the fuse operate?".
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
but I think this circuit , shows a few more pieces.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
In schematic diagrams this is the symbol for a fuse:
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
nine
Can the fuse protect the electronic devices from lightning instead of a surge protector.
What is lightning?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
what exactly is a ‘surge’ protector?
The bolt then partially travels down the line to your home.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
This is 'the assistant's answer'
One is “what exactly is in a ‘surge protector’ ? ”
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
At one ohm, the resistor has a maximum of 1 watt power.
For this case there are devices called Metal oxide varistors (MOV).
He then describes the function of a fuse.
A fuse is a non-resetable over current circuit protector.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
These are simplified answers to the original question, and does not change anything I wrote above.
so, what happens?
An AC voltage/ current source, and an ac inductive load.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
At least they know the answer if they wanted it.
One
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This one hit behind the barn.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This is where the MOV conducts again, and dissipated the energy.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
I post the exact comment here.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
These devices are installed between the “hot” and “neutral” and protective ground.